2SW100 Ignition Switch- Unique (2 position)(2 keys) for Classic Diablo / Magellan

It’s usually connected with a red or yellow wire, depending on your car model. This terminal controls and distributes power to the ignition and other car electronic components. The BATT is the terminal to which a thick wire with a red coating connects to. So, if you have a new modern ride, you have four wires in the ignition switch, labeled īATT (Battery). New modern vehicles usually have four wires in the ignition switch. But first, let’s see the wires that go to the ignition switch. This article will walk you through the steps needed to wire your vehicle’s ignition switch. Thankfully, it is not a complicated process to handle once you have the know-how. You never know when it might fail, so you need to understand how to wire the ignition switch.

Replacing the ignition switch becomes imperative when it becomes difficult to turn on the vehicle’s electrical system or when it fails to signal the starter motor to stop turning once the engine starts running. The ignition switch is responsible for turning on the circuits or signals that get the vehicle to start.

2SW100 Ignition Switch- Unique (2 position)(2 keys) for Classic Diablo / Magellan